Lugares peligrosos (clasificados) — clases y divisiones

Class tells you the material — I gases, II dusts, III fibers — and Division tells you the likelihood: Division 1 where the hazard is present in normal operation, Division 2 where it is only present abnormally.

Get the classification right first, because every equipment and wiring-method decision downstream flows from it. Guess low and you install gear that becomes an ignition source.

When it applies

This is the front door to hazardous location work. Article 500 sorts an area by what flammable material may be present — Class I gases and vapors, Class II combustible dusts, Class III fibers and flyings — and by how likely that material is to be in the air during normal operation versus only under fault. That classification decides every fitting, seal and enclosure you are allowed to use.

Common mistakes

• Guessing at the class and division instead of using the facility's area classification drawings.
• Confusing the Division system with the Zone system and mixing incompatible equipment ratings.
• Assuming a whole room is classified when the boundary actually steps down by distance from the source.

In the field

I never energize a thing in a classified space until I have the area classification documents in hand. Precise boundaries and gas groups are not paperwork for its own sake; they are the map that keeps a spark away from a vapor cloud.